***Mods could we sticky this please***
Ok. we forgot to take pics on the first side, and it went way too easy... so we took pics on the other side.
here is the spacer shim and hardware for 1 wheel.
Before adding 10mm Randode Spacer Shim:
Break the lug nuts loose, then jack up and support vehicle with jack stands.
Remove the wheel to expose the brake drum.
Make sure the parking brake is released and pull off the drum.
Locate and remove the four hub bolts with a 14mm socket and ratchet.
Locate the ABS sensor wire on the back of the hub. there is a plastic cover over the plug that must be removed to access the button on the bottom to release the plug.
At this point the hub can be removed.
Pull the brake backing plate away from the axle flange and slide the spacer shim into place.
Line up the shim and put the backing plate back into position.
Put some red loc-tite on the supplied bolts and bolt the hub back on. Leave the bolts loose until all four have been started. Torque to about 40 foot pounds.
Plug the ABS sensor wire back onto the hub.
Reinstall drum.
Put the wheel back on, torque it down, and lower the car back to the ground.
stand back and admire your new wide stance.
Spacer shims now in stock for xA, xB, xD, and Yaris...Cube coming soon.
Threaded Mode
